i have a rme fireface ucx and rme fireface 400 how can i configure fireface ucx master and fireface 400 slave through adat channels

Kindly search forum or open a new thread ... but please do not hijack a thread which is about another specific topic, thanks.
It makes it easier for other customers like you to find relevant information quicker.
Thanks for your cooperation.

i have a problem with a babyface (FW 225) and iPad Pro (iOS 13.3.1). I can use it in compliant mode with garage band and the iOS TotalMix App, but when I use the "iOS Screen Recorder" the files can not be saved (Error 5823). I have another audio device (line 6 sonic port vx) and with this device everything is working finde. Can somebody reproduce the error?

Cheers
Anselm

That chapter describes how to set it without the computer.

Oh. I see.

Sorry. I think i didn't have the right pdf. I've just downloaded the user manual from this site and, effectively, it appears.

Thanks a lot.

Manual chapter 32, Operation at the Unit, Set Clock Mode and Sample Rate.

Thanks for the answer.

But, Do you mean if I change this setting in with a computer it would remain like that in standalone mode?

Is there a way to switch the Babyface directly to 48 khz in standalone mode?

I mean, without a computer, Ipad or any SPDIF/ADAT signal.

Thanks in advance.

Edit: I know I could bypass spdif out to spdif in with that loopback trick and use the analog ins to the analog out, but I'd like to try and save one conversion and one cable.

Did you install the TotalMix FX app on the iPad? That should show you what is going on. Phones out is 3/4 so if the app is playing out of 1/2 you would need to route that signal to Phones 3/4. Or set the Babyface to 2 in / 2 out mode, also done in the TMFX app settings.

And just like that, problem solved. Thank you for helping this humble noob!

I'm coming from Mac+Duet and I suspected there might have been some depth to wade through getting an iPad/Babyface system going. Thanks for making it easy Jeff!

Jeff wrote:

You have the unit in CC mode and a power supply connected?

Whoops! My bad, I didn't hold the buttons. Just tried and now all seems well. Reading the instructions fully would have helped... Thank you Jeff!

Well I spoke too soon. I can't get any audio output in CC mode. The meters show audio from the iPad but nothing comes out of the headphones out even when it's cranked. I tested this babyface on my MacBook Pro and I do get audio out of the headphones with the Mac, just not in CC mode. I checked and it has firmware 223. Is there anything I may be missing or should I send this back?

You have the unit in CC mode and a power supply connected?

Whoops! My bad, I didn't hold the buttons. Just tried and now all seems well. Reading the instructions fully would have helped... Thank you Jeff!

Thanks

Best,
Darren