You simply missed that you have to use a password per user, and the user has to use that password. Then User Management will work.

I was away for a while, and now that I come back to it and see that it does work of course, I don't want to miss to say thanks for your patience and support folks, Appreciate it
Zsolt

Yes - thanks for reminding me

There is a contradiction that I do not understand:

In order to be able to have a connection from my iPad to total mix, I have to switch off the manager.
In order to be able to give access to total mix to my fellow musicians, I have to enable the manager.

Now what? What am I missing?

You simply missed that you have to use a password per user, and the user has to use that password. Then User Management will work.

However, user management is useful if you want granulize certain access rights for certain submixes for your fellow musicians.

If not, disable user management, and all will have access to all

If you want to split it, that only you should have "full" access, enable it and give "your user" full rights by ticking "Do" radio (=Do all)... and the others the respective limits...

Again, its all described in the built-in help, I mentioned in #4

There is a contradiction that I do not understand:

In order to be able to have a connection from my iPad to total mix, I have to switch off the manager.
In order to be able to give access to total mix to my fellow musicians, I have to enable the manager.

Now what? What am I missing?

...shouldn't it be possible to use the user management option for fellow musicians?

It is possible! As user management is exactly for the use case you mentioned...

Assuming you mean with "fellow musicians" that each one has its own TM Remote running...

- In TM built-in help, read this chapter: 8.2 Settings
- In TM Remote built-in help, read this chapter: 2. Quick Start (Network Remote Settings, User Authentication)

2) Regarding "no access!" -> Disable User management in network remote settings of TM.
Exactly this has been resolved yesterday here: https://forum.rme-audio.de/viewtopic.ph … 54#p251654
(I wonder how you could oversee it, as the title contains "no access"?)

I swapped my UCX II for An UFX II on Mac.
I am having troubles with Remote on iPad. It loses connection and then, when I restart the app on iPad it says: UCX II connected - and switches to offline after a couple of seconds. There is no UCX II.

For some reason in network remote settings on the Mac I have two IP numbers.
On iPad I enter one of them, and it displays UFX correctly, but says: no access! And below (Found devices) it shows both UCX and UFX
With the other IP the same thing, but it shows no found devices.

Cache?

Tanks for support