Topic: Digiface Dante not outputting via MADI
Hello...I was attempting to run the Digiface Dante by sending a signal out from the computer through MADI to another set of devices. Intially it was a digico console, and when the digico wasn't seeing the signal from the Digiface Dante, I tried two separate Tascam DA-6400's that both have MADI and Dante inputs.
None of these devices saw the MADI stream from the digiface dante.
I have the latest drivers and firmware installed and am using a signal routed to MADI outputs 1 & 2 via TotalMix. The mode in the driver is set to MADI mode (Not wordclock).
The unit receives data via MADI from all the devices used (I see "sync/lock" shown in the driver window along with the mode and sample rate) however no output data or even detected by the Digico and the tascam units.
I'm starting to think this is a hardware issue as I can't see any other reason that the unit wouldn't be sending out the MADI stream.
Can anyone think of anything I haven't done to enable MADI output or, at very least, check if the unit THINKS it is sending MADI data out? Is there a driver update that I should be using?
BTW: Computer is a Macbook Pro running Mojave
Cheers & Thanks