1 (edited by jaychoupp 2021-09-29 00:30:33)

Topic: Adi2Pro and Cubase ControlRoom

Hello Everyone!^_^

I want to send 2 separate signal to my monitor(Analog Out 1/2) and headphones(Analog Out 3/4) using Multichannel Mode in Cubase Control Room,and control volume separately

Now the problem is it seems to work in Cubase,the headphone output I set in CR have signal shown in Cubase,but it cant be sent out through ADI2Pro,instead the signal I send to my monitor(Analog Out 1/2)always influence the volume of my headphones,that means if I turn down the Monitor send in CR,the headphones will not have any sound,too

I'm a bit confused here,Isnt those sends separate?

2

Re: Adi2Pro and Cubase ControlRoom

Did you change the Pro to be in Multichannel mode? If so then check the Source setting in the Phones 3/4 I/O menu.

Regards
Matthias Carstens
RME

Re: Adi2Pro and Cubase ControlRoom

MC wrote:

Did you change the Pro to be in Multichannel mode? If so then check the Source setting in the Phones 3/4 I/O menu.

It's the source selection……thanks a lot!!!