Topic: midi remote access to 648 over madi trouble

i am having trouble accessing 648 from daw with madi card. I have selected madi port 3 as both input and output in the app but continue to get no response and offline messages

all lights on the 648 ensure me that it is in sync with the madi card..

perhaps this is because i am in 64 channel mode?

2

Re: midi remote access to 648 over madi trouble

Old unit: Did you read the manual and connected MIDI in to MIDI out at the 648?

New unit: you switched Remote to MADI on the front?

Regards
Matthias Carstens
RME

Re: midi remote access to 648 over madi trouble

i didnt see the remote switch there ... thanks MC..

i read everything - but do not retain it all.  Coming from a stereo system to this ... blows some of the mental circuits. 

Thanks Again... MOst Kind.

Re: midi remote access to 648 over madi trouble

MC wrote:

Old unit: Did you read the manual and connected MIDI in to MIDI out at the 648?

New unit: you switched Remote to MADI on the front?

I'm just converting over from a raydat, to a HDSPe MADI, and an ADI-648.

I'm having this problem.

Software says 2.5 when it comes alive, and I do have the Remote switch set to madi.

I have the software midi i/o set to MADI Midi Port 3 for input and output.

It doesn't find the ADI-648 for some reason. No Response.

5

Re: midi remote access to 648 over madi trouble

Try port 1.

Regards
Matthias Carstens
RME

Re: midi remote access to 648 over madi trouble

I just tried all three. Same, No response.

Is it possible to do a sysex dump, or force the 648 to send some midi using the front panel? I could use the midi monitor in studio one to see if it does transmit data.

7

Re: midi remote access to 648 over madi trouble

Did you set Options, Select Device to 'all'? And then hit 'Start/Stop MIDI I/O'?

If you change a button on the front that will be transmitted as MIDI message.

Regards
Matthias Carstens
RME

Re: midi remote access to 648 over madi trouble

I did. I tried all of the devices, and "all"

I will try hitting some buttons tonight. Thanks for the help.

Re: midi remote access to 648 over madi trouble

It wound up being that the input selection on the HDSPe MADI was set to optical, when the adi-648 is on coax.

Thanks for the help.