• Registered: 2015-05-10
  • Posts: 6

Topic: Bug with Groups with Main

I have following problem if I make Groups with "Main":
* Making Fader Group1 (Edit-->Group-->Edit-->1):
    Selecting hardwareinput AN 7/8    and   hardwareoutput AN1/2   and   Main  (Routing all with 0dB)
* Closing "making Fader Group"  with -->Edit: all selected Sliders are getting red.
* Store in snapshot 1
* Setting Slider of Fadergroup to -30db:  complete fadergroup (all 3 Sliders) gets -30dB
* Store in snapshot 2
* Selecting "snapshot 1":   only hardwareinput AN 7/8  gets the stored value of snapshot1  -->  hardwareoutput AN1/2 and Main is remaining on old Level -30dB!!!!!!

If I take  "hardwareoutput AN3/4"  instead of "Main" all functions are correct.
I Have same problem if I take "Workspace save and load" instead of snapshots

Please can anyone check the behaviour on his  Totalmix?

I have RME Fireface UCX (vers 1.61 and newest Firmware)

  • Registered: 2019-09-02
  • Posts: 21

Re: Bug with Groups with Main

In totalmixfx preferences, under snapshots is 'main volume' selected as do not load?

mark.cull's Website

  • Registered: 2015-05-10
  • Posts: 6

Re: Bug with Groups with Main

Thank you. This was the simple problem. ......and I searches the whole day.
Totalmix-->Options-->Preferences-->Snapshots --> Do not load:   changed from "Main Volume"   to   "-----"