Topic: Noise At Mic/ Line Preamp / Rme UCX
Hello
At Mic/ Line Preamp 1 (front panel)i have a noise always even with no connected mic or any other cable on the rme ucx
Check video https://tinyurl.com/v933bun
Any solution?
Best Regards
You are not logged in. Please login or register.
RME User Forum → TotalMix FX → Noise At Mic/ Line Preamp / Rme UCX
Hello
At Mic/ Line Preamp 1 (front panel)i have a noise always even with no connected mic or any other cable on the rme ucx
Check video https://tinyurl.com/v933bun
Any solution?
Best Regards
Thats the typical noise of a feedback loop, because you send the recorded Mic signal to the connected monitors.
Hi Ramses
How i can change that?
I dont connect any microphone or any cable at the Mic amp 1 and the signal is green always at front panel ... Sorry if is a dummy question!
TM FX -> Submix mode
Click to the HW output where your Monitor is connected to (submix).
Turn down the fader of Mic input.
See also manual, RME tutorials, my step by step primer.
https://www.tonstudio-forum.de/blog/ind … rnal-equi/
https://www.tonstudio-forum.de/blog/ind … al-Videos/
That is not noise but a pure tone. And the first time I see feedback stopping when applying gain. You should disable the Dynamics to further evaluate this issue.
Hello Mc
2 questions
1)How that tone is there? No mic or any cable connected
2)How i can disable the Dynamics? I dont find that in manual
Thanks in advance
In that channel the D symbol is yellow, so you activated Dynamics...
Hi Mc
Please check the video https://tinyurl.com/vwjqqua
Is not about dynamics,the noise is there always...maybe need a hardware service?
Seems so. Although I have never seen this kind of error so far.
Thanks MC,
Yes the problem is strange
i will install the latest drivers firmware,reset, and if the problem remain i will send the ucx for service
Please let me know how you solve the problem.
RME User Forum → TotalMix FX → Noise At Mic/ Line Preamp / Rme UCX
Powered by PunBB, supported by Informer Technologies, Inc.