Topic: Diagnosis of problems with UFX
I hope that you're all doing ok during these difficult times.
I'm running a UFX in a manner that uses both AES and Analogue Outputs with this working as expected for quite some time. The current situation, however, is that the AES output is working fine the Analogue Outputs don't seem to be able to drive (active) monitors despite the fact that TotalMix shows that the hardware outputs are working. Is there anything that can cause TotalMix to show hardware outputs working fine but for no signal to be output? Any ideas as to the potential problem?
Edit: Is it possible to use the Phones Outputs as a normal Analogue Output? I guess that this is an alternative to test