Topic: ADI-2 Pro FS: missing routing possibilities?
Hi,
I'm struggling to simultaneously route ADI-2 Pro FS SPDIF input to AES output and analog inputs to SPDIF outputs. Should this be possible?
I'm using ADI-2 Pro as a standalone format/AD/DA-converter and a headphone amp, combined with Digiface USB. Digiface is there just for TotalMix monitoring and loopback features for inter-app audio routing, as ADI-2 Pro does not support TotalMix.
The connections are as follows:
- external mic preamps -> ADI2pro analog inputs 1-2
- ADI2pro optical SPDIF out -> Digiface USB optical SPDIF in
- Digiface USB optical SPDIF out -> ADI2pro optical SPDIF in
- ADI2pro AES output to Genelec AES input
- Digiface USB connected to computer with USB
With headphones only, this setup works like a charm in AD/DA mode and "Dig. Out Source" set to "Default". This way, I can monitor the SPDIF input through PH3/4, but I can't route the same signal to AES output for monitoring through the speakers. If I switch "Dig. Out Source" to "Main Out" and Main Output "AD/DA Source" to SPDIF, analog inputs 1-2 are not routed to ADI2pro SPDIF outputs anymore, but a feedback loop is created instead as SPDIF input is then routed to SPDIF output and monitored via TotalMix. I would like to keep everything else as-is and change just the source of the AES output (SPDIF in -> AES out while routing analog inputs to SPDIF out). Any ideas?
Thanks!
---
Tommi Gröhn
CTO
oeksound Ltd.