Topic: Need Help. Fire Face 802
Hi all,
Hope all is good and every one is staying safe and well.
I am trying to hook up my new RME Fire Face 802 Via ADAT. I have tried everything i could think of. Please be patient with me.
Installation: All USB drivers installed successfully.
Channel count visible in LOGIX PRO X is 30/30
FF802 connected with USB
DIGI 003 connect through Fire wire
Link Connection: ADAT cable
FF802 ADAT port 1: out Going into in of DIGI 003 ADAT
FF802 ADAT port 1: in going into out of DIGI 003 ADAT
Sync:
FF802 USB setting panel: Set as 44.1, Master => ''INTERNAL'' Lit green on front penal no Flashes
DIGI 003 Audio Penal Set as 44.1, Slave => ''ADAT'' Lit green on front panel no flashes
TotalMix:
From Software playback, I tried to send signal to hardware output ADAT channel 1/2 it was ok by the display meter.
Where My issue is:
I have tried to send signal from Hardware ADAT output 1/2 to Hardware ADAT input 1/2 there is no display meter showing green
I did the same thing for all 8 ADAT channel same result, no signal coming in
While am trying to take advantage of the IO routing in RME, My aim is to be able to use all my outboard FX instead of a Patch bay
on the Signal chain:
FF802 out put 3/4 goes into Fatso and from out of Fatso, back into input 3/2 on FF802
Same for FF802 5/6, 7/8 to outboards back into same channels on the input side of the chain.
FF802 1/2 (in) are connected to Prophet, and 9/10 to Yamaha, nothing on 11/12 input.
Digi 003 signal chain:
output (1) goes into (in) of Retro compressor and out of retro comp to (in) put 1 of DIGI 003
I did the same process for the 8 channel on the DIGI 003
This is what I have done so far, but it is not working and hope you guys will help me.
Thank you
Dprincewillz