1 (edited by Exposure 2020-10-17 23:14:01)

Topic: Digicheck with PC setup (RME Fireface 400)

Hi guys, hope you're good.

Trying to setup Digicheck with Windows 10 and a Fireface 400 as per this video - https://www.youtube.com/watch?v=3cAiit0GbY8

However, I can't change the input in device input settings to ADAT - only analogue in. (see pic)

https://pasteboard.co/Jw7EE4DD.png

help much appreciated.

Exposure.

2

Re: Digicheck with PC setup (RME Fireface 400)

Open the FF400 Settings dialog. It is limited to Analog right now.

Regards
Matthias Carstens
RME

Re: Digicheck with PC setup (RME Fireface 400)

MC wrote:

Openm the FF400 Settings dialog. It is limited to Analog right now.

Thanks for your reply. Do you mean the Total Mix settings?

4

Re: Digicheck with PC setup (RME Fireface 400)

No, he means the Fireface Settings - the one with the flamey, reddish-orange icon, which does NOT have a mixer or faders in its window. That's where the FF400 and FF800 change the number of inputs which are activated. Look for where it says, "Bandwidth Limit".

Frank Lockwood
https://LockwoodARS.com
Fireface 800, Firmware 2.77
Drivers: Win10, 3.125; Mac, 3.36

Re: Digicheck with PC setup (RME Fireface 400)

fl wrote:

No, he means the Fireface Settings - the one with the flamey, reddish-orange icon, which does NOT have a mixer or faders in its window. That's where the FF400 and FF800 change the number of inputs which are activated. Look for where it says, "Bandwidth Limit".

Hi, yeah I've got the Fireface settings and have selected 'All channels' whereas before it was just showing 'Analouge'.

I've now got what appears to be a signal in the analyser but it's stuck ie not responsive and stays when the track has stopped.

https://ibb.co/6YG9mSW

Re: Digicheck with PC setup (RME Fireface 400)

I have it working now, thank you all for your help.