• Registered: 2021-01-11
  • Posts: 2

Topic: ADI-2 DAC Line Outs stopped working

Hello,

I've  had the ADI-2 DAC for a while and it has always worked flawlessly, including last night.  Today for some reason the line outs no longer function - both the XLR and the RCA outputs no longer produce any sound coming out of the amp (I've tested it with two different amps - a Massdrop THX 789 on the XLR outs and a Koss ESP 95/X Energizer on the RCA outs). 

The spectrum analyzer shows that the ADI-2 DAC is receiving a signal, and the headphone output on the ADI-2 functions normally, it's just the line-outs that no longer work. 

Is it possible there's a setting I may have changed that could cause this behavior, or has my unit suffered an internal failure that will require it to be sent in for repair?

Thank you.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,823

Re: ADI-2 DAC Line Outs stopped working

The Line Outs might be muted. Check that in I/O - Line Out - Settings, at the bottom of the list.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2021-01-11
  • Posts: 2

Re: ADI-2 DAC Line Outs stopped working

MC wrote:

The Line Outs might be muted. Check that in I/O - Line Out - Settings, at the bottom of the list.

Ah, that was it!  Thank you, I'm not sure how I managed to set them to mute.