1 Topic by waedi (edited by waedi 2021-01-31 00:38:31)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 634

Topic: How to connect Madi devices ?

Connecting 2 devices ( Madiface Pro and Quadmic XTC ), very simple, just connect the madi optical cabel with the madi socket on each device, done. Right ?

But how to connect 3 devices ? Madiface Pro and Quadmic XTC and a M-32/M-16 DA ?

Shall I cut a Madicable plug into two pieces ?

Or do I need to replace the Madiface Pro by a Madiface XT ?

Just wondering

OSX M1, Babyface (soundstudio-to-go), started with PST8, Multiface I, Multiface II, PCIeMadi

2 Reply by lightbox (edited by lightbox 2021-01-31 00:37:20)

  • Registered: 2018-05-05
  • Posts: 125

Re: How to connect Madi devices ?

create a ring connection. No need to cut the plug into 2 pieces, they actually ARE 2 pieces already. Just watch closely how you can open the clamp. wink

3 Reply by waedi (edited by waedi 2021-01-31 00:40:42)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 634

Re: How to connect Madi devices ?

Ahhhh !
Great !
Simple as possible !
I was close.

OSX M1, Babyface (soundstudio-to-go), started with PST8, Multiface I, Multiface II, PCIeMadi

4 Reply by ramses (edited by ramses 2021-01-31 12:33:13)

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 7,638

Re: How to connect Madi devices ?

https://archiv.rme-audio.de/products/madi-setups.php

https://www.tonstudio-forum.de/blog/ind … XTC-DE-EN/

Or from a blog article / review from me about 12Mic
https://www.tonstudio-forum.de/index.php/Attachment/2648-03-Use-Cases-jpg/

Or this one:
https://www.tonstudio-forum.de/blog/ind … Cber-MADI/

https://www.tonstudio-forum.de/index.php/Attachment/1774-UFX-und-Octamic-XTC-Bild-2-Rear-MADI-Cabling-jpg/

BR
Ramses
X10SRi-F, E5-1650v4, Win10Pro20H2, Cub11Pro, UFX+ (v0.9735), XTC, 12Mic, ADI-2 Pro FS R BE