• Registered: 2021-09-10
  • Posts: 10

Topic: Overheated wire connection in ADC input mode

Dear Support Team
I convert analog signal to digital signal, using record software: audacity
Analog power source about 1W, maximum voltage 8V.
However, after about 30s - 60s, the connection wire is very hot
Please explain what makes the connection wire so hot ?
And is there any way to fix it?

2 Reply by KaiS (edited by KaiS 2021-09-10 06:30:16)

  • KaiS
  • DAW Mastermind
  • Offline
  • From: Germany
  • Registered: 2020-02-05
  • Posts: 3,121

Re: Overheated wire connection in ADC input mode

thuongdd93 wrote:

Dear Support Team
I convert analog signal to digital signal, using record software: audacity
Analog power source about 1W, maximum voltage 8V.
However, after about 30s - 60s, the connection wire is very hot
Please explain what makes the connection wire so hot ?
And is there any way to fix it?

Likely the cable has a short or is miswired for the purpose.
Try another one.

For detailed analysis more information is needed: source (power amp?), cable type/plugs, connection to ...

Does the connection work at all, do you get audio on the ADI-2 (Pro?)?

KaiS's Website

  • Registered: 2021-09-10
  • Posts: 10

Re: Overheated wire connection in ADC input mode

I check the sound source from the phone and i used short cut wire.
I will try with standard cable and feedback to you