Topic: Factory reset
I wanted to do a factory reset on my new adi2-pro fs BE. I followed the manual.
Switched the device off (red ring)
Unplugged the USB cable
Hold encoder 1, 2 and Volume
Switched on the device and hold the encoders untl a message shows
Showing the message is the problem: according to the manual there would be a message 'reset done'. Not in this case. After a while there is a message 'Preamp activate (which is factory default without USB connected).
How can I be sure that the factory reset is complete and done.
Before all this I did a firmware update from 112 to 116.