Topic: Assigning setup to Buttons.
I made two setups on my ADI2 pro fs BE.
Setup 1: mode preamp, clock 96kHz
Setup 2: usb mode,
Switching between the two through the menu setup, load 1, or load 2 is working. However after switching back from USB to the setup 1 mode the stored clock is not changed and stays on the last USB value. But this isn’t the topic of this post.
I follow the assigning procedure of the manual to store the two setups under the buttons Vol. And I/O, by switching the Remap button from Remote to On and then assigning the setups to the buttons.
After leaving the setup menu, pushing short the Vol. Button a message tells me to confirm the choise by pushing the button a second time, and it switches to the assigned setup.
After pushing the I/O button I get the normal action of that button. Trying Vol. again gives me the normal volume screen.
Checking the remap function in setup reveals the original settings of the two buttons and not the chosen setups.
Anyone an idea what goes wrong?