Topic: Showing "Phones" on the Display
Short version: How do I set the volume / "dark volume" screen to show the information for "phones"?
A newbie question:
I am using an ADI-2 DAC FS with headphones. I have it set as I think I like it (crossfeed, ...) - however, the "main screen" (it is called "Dark Volume" on p29 of the manual) tells me the status of the Line Out (where I am not using crossfeed or loudness or ...).
Last night (my first night with the device) I could have sworn it was showing me the status for the phones output on the main display. But this morning, when I turn it on, I cannot figure out how to switch it to show me the status for Phones. If I dig into the menus, I can confirm that the device has the settings I expect, but I cannot figure out how to have the "dark volume" screen show the info for the "phones" output.
Similarly, If I go to the "volume" screen (pressing the vol button to show volume/balance) - it shows me the info for line out - I do not see how to switch it to see the info for phones.
I understand the the user experience of this device is going to take, um, some learning - but I am hoping someone can explain to me how to get the basic info shown on the display for normal use. (my normal use will be as a headphone DAC).
Thank you!
Mike