• Registered: 2022-09-03
  • Posts: 1

Topic: UCX 2 analog channel all levels full on up "noise".

My 1-8 analog channels blast full on red. Nothing is connected, channels are muted and gains down. When I disconnect the device from usb it shows all analog channels full on red on the the device - a bit of a stuttering/on and off going on. The problem sometimes disappears for a moment but comes back on with a nasty audio surprise. I updated firmware and drivers. No change.  I assume faulty hardware? Warranty is still valid.  Early 2022 device.

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 3,340

Re: UCX 2 analog channel all levels full on up "noise".

Did you try a full reset in Totalmix ?
Otherwise I would say, send in for service !

M1-Sonoma, Madiface Pro, Digiface USB, Babyface silver and blue
  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,547

Re: UCX 2 analog channel all levels full on up "noise".

Can you test this with another power supply?

Regards
Daniel Fuchs
RME

RME Support's Website