• Registered: 2024-08-09
  • Posts: 2

Topic: DPS-2 LEDs

Hello,
I've connected DPS-2 to ADI-2 DAC FS using DC microFilter output.
When I power on DPS-2 the LEDs sequence is: both LEDs ON red for a second, LED corresponding to the selected output ON white for 15 seconds, then both LEDs OFF and stay OFF.
Manual states that both LEDs should be ON in white and not in red at the powering on, so I'm asking if my unit is OK.
Apart that difference in color all seems fine.
Thanks
Stefano

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,592

Re: DPS-2 LEDs

During start-up time the LEDs are indeed red for a short time. That matches the output voltage which is not yet there/high enough.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2024-08-09
  • Posts: 2

Re: DPS-2 LEDs

Understood,
Thanks Matthias.

Regards,
Stefano