• Registered: 2015-10-29
  • Posts: 72

Topic: Speaker B and a SUB setup

Hi all,
I run a UFX III and am trying to work out how best to set this up.
"Speaker A" configuration has two Genelecs as L+R (Output 1+2) with a Sub on Output 3.

I have these outputs grouped so as I raise the volume (Using ARC USB) the sub adjusts accordingly.

I have a "SPEAKER B" Setup which is a MONO Avatone MixCube. (Output 5+6)

When I switch between "A" and "B" the Sub (Output 3) stays on. How do I mute the Sub so I only get a MONO Output 5+6 (Summed) to the Mixcube?

What is the best way to set this up please? Speaker A and B with "B" not using the sub?

Thanks all!

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 7,061

Re: Speaker B and a SUB setup

I would not use the Speaker B feature in this scenario.
Speaker B is switching between two sets but you have three.
Instead create two snapshots with volume up or down for the outputs.
Use the ARC to load snapshots, it is the same as switching A/B

M1-Tahoe, Madiface Pro, Digiface USB, Babyface silver and blue
  • Registered: 2015-10-29
  • Posts: 72

Re: Speaker B and a SUB setup

Thanks @waedi, I will give it a go

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 7,061

Re: Speaker B and a SUB setup

The sub on output 3, is this not Genelec ?
Why is this sub on an own analog output and not connected to the other Genelecs ?

M1-Tahoe, Madiface Pro, Digiface USB, Babyface silver and blue
  • Registered: 2015-10-29
  • Posts: 72

Re: Speaker B and a SUB setup

It is a Genelec sub,....but it's actually part of a 5.1 system.....when I mix on Logic, I keep all the speakers on their own "outs"

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 7,061

Re: Speaker B and a SUB setup

I see, your descision your complications your hobby, no problem

M1-Tahoe, Madiface Pro, Digiface USB, Babyface silver and blue