• sc00t
  • New member
  • Offline
  • Registered: 2026-07-31
  • Posts: 1

Topic: Switch Level {Red|Yellow} vs Ref Range

Hi Guys,

This is a quick bug/feature request. I have my system calibrated to -18db = 0db(VU).
I have a dedicated display to enhance the UFX, which works and look amazing running DigiCheck NG.

One mini issue is that the program meters and level meters stop their Switch level red/yellow settings capped at 0db. However, I need this to be 18db (for red in my case) to match the clip at -18db ref. 

I can type in 18db into the text box and it works fine. However, when saving (or reloading) the workspace via quick select, the 18db will again be capped at 0db.

Could you please extend the range of these "Switch Level Red/Yellow" to match the Reference Level.

Thanks guys,
Scott

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 27,110

Re: Switch Level {Red|Yellow} vs Ref Range

I cannot completely follow here. The two channel level meter works as expected, -18 dB for red change can be set and is again set when loaded via workspace.

With the program meter the color change is limited to +12 dB, which should be obvious from the UI. When setting +18, then  reloaded it does not fall back to 0 dB but the expected +12 dB.

So if this is the issue we should be able to extend that limit to +18 dB in the next version of DC NG.

Regards
Matthias Carstens
RME

MC's Website