• Registered: 2026-08-30
  • Posts: 1

Topic: Changed digiface dante to static IP address in Dante. Can't access to

Trying to configure AES67 (to communicate with a Dolby Cinema Amp)
Changed to a static IP address in Dante Conroller
Dante not happy obv.
Can't get to settings to set it back
It is currently working as WDM
would like to get it back into dante.
Any idea how I can rest it to DHCP?

Stuck on this screen:

Dante Controller has discovered an address for device 'Lennox-1-MADI-DANTE-Interface' that does not match the subnet configuration of the local Dante interface 'Ethernet 3'.
Possible causes of this problem include:
Local Dante interface has link local address which is different to the device subnet
Device has a link local address which is in a different subnet to the local interface
Details:
Resolved device address on Dante interface is 192.168.1.151
Local address on PRIMARY Dante interface 'Ethernet 3' is a Link Local 169.254.243.221/255.255.0.0

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 11,142

Re: Changed digiface dante to static IP address in Dante. Can't access to

Which settings are you referring to  that you can't get into?
What does "working as WDM" refer to?

You may need some local DHCP, is there a router or so or is it just two devices connected to each other?

Regards
Daniel Fuchs
RME

RME Support's Website

  • From: Haimhausen
  • Registered: 2012-04-02
  • Posts: 414

Re: Changed digiface dante to static IP address in Dante. Can't access to

Use a router which you set to the LAN from Ip-range 192.168.1.1
Then connect the DF Dante and the computer to that router and you can reach the DF Dante again in the Dante controller

Regards,
Audio AG Support

Audio AG Support's Website