• Registered: 2011-01-11
  • Posts: 23

Topic: ADI-8DS config for external sync via adat

Hi all,

Can anyone clarify what the correct config is of the buttons on the front of the ADI-8DS for use with an E-MU 1212m, with the 1212m as master clock? Litepipes hooked up both ways between the units.

I know that the D/A button should be on INPUT, but should the A/D button be on INPUT or INT? Presumably INPUT as well? I couldn't work it out from the manual.

"INPUT" on the A/D side makes little sense as there is no digital input on the A/D side, so presumably setting INPUT on the A/D section actually means the input of the D/A litepipe, the same as setting INPUT on the D/A section?

If the D/A is set to INPUT, and the A/D is set to INT, is that going to cause problems in a closed loop system like this one?


Thanks!

Gary.

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,547

Re: ADI-8DS config for external sync via adat

Input is correct... That way, both AD and DA will sync to the incoming ADAT signal.

Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

  • Registered: 2011-01-11
  • Posts: 23

Re: ADI-8DS config for external sync via adat

Thanks for a super-fast response Daniel!

I started another topic about the 1212m and the ADI-8DS, would be grateful if you take a look...

Thanks!

Gary.