Topic: HDSPe RayDAT: Choppy Playback in CuBase 6
I just installed an RME HDSPe RayDAT in my home studio PC, and I've got a problem I can't seem to get past. I can hear sound when I play audio from Cubase 6, but it's VERY choppy - lots of clicks, pops, and artifacts - it sounds so bad it's pretty much unusable. Any ideas would be greatly appreciated! Below is a quick summary of my current setup and configuration settings:
Audio Hardware:
- RME HDSPe RayDAT PCI-express card with ADAT expansion (4 in, 4 out)
- Presonus Central Station (toslink/spdif input supports up to 24-bit/192KHz)
Configuration details:
- RayDAT "ADAT4" output is connected to Central Station "toslink" input
- RayDAT Hammerfall DSP Settings: buffer set to "32", clock sample rate set to "44100 Hz" (ghosted), source set to "Internal", Pitch set to "0%", SPDIF Out "ADAT4" selected, Word Clock Out set to "Single Speed"
Computer/Software:
- Windows 7 64-bit on an EVGA motherboard, 1st-gen Intel Core i7
- CuBase 6 with Hammerfall ASIO drivers enabled