• Registered: 2011-06-09
  • Posts: 12

Topic: FFUC Knob not working, only stays as panning for AS1/2

Hi,

Refer to the above matter, no matter what I did, re-flash the unit, reset the unit, the unit's knob just doesn't work anymore.

Other functions are ok, excepet this, can't even assign the knob to anything else.

I'm currently residing in Malaysia but the unit is from UK, to send it back, it's a big hassle.

Please help.

Thanks.

Lee

Very happy user of RME FF800 + FFUC (less happy now)

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: FFUC Knob not working, only stays as panning for AS1/2

The knob is too far in. Pull it off carefully a little bit.

Regards
Matthias Carstens
RME

MC's Website