• Registered: 2008-11-20
  • Posts: 8

Topic: No sound after sleep

Hello! After uggrade to lion 7.2 . Logic 8 don´t get any sound after sleep with fireface 800. driver3.00.  With built-in audio no

problem.

Found this  system messsages 2011-11-13 15:39:14,257 Fireface Mixer: ATS: Invalid FontObjectID (3) - only low 16 bits

are being passed in. Can this be the problem?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: No sound after sleep

No, that message is harmless. What is your hardware?

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2008-11-20
  • Posts: 8

Re: No sound after sleep

Hello! My hardware is mac pro 08

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: No sound after sleep

We will check.

Regards
Matthias Carstens
RME

MC's Website

5 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,599

Re: No sound after sleep

We tested with our Mac Pro under 10.7.1 and 10.7.2, driver 3.01. In no case audio was lost after sleep, even when the FF800 had been switched off/on in-between.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2008-11-20
  • Posts: 8

Re: No sound after sleep

Thanks for checking. I make an clean installtion of lion 7.2 and there are still same problem. But if you right it must be something in my system that are not good. Have you any idea what I can do.


With regards claes-å Schlönzig