• BOWIE
  • ADAT user
  • Offline
  • Registered: 2012-05-11
  • Posts: 27

Topic: No headphone output in stand-alone.

This is likely simple, but I already spent 3 hours trying to figure it out.   Until last week, I was able to plug an analog source into my UFX and I could hear it in the headphone jacks.   I can see input in the UFX meters but no output.   I have checked gain and mutes to no avail.  Is there something I need to adjust in the TotalMix settings? Note: the headphones work fine when the computer is on and I'm monitoring through TotalMix.  The problem is only when the UFX is running on it's own and it used to work in this mode.
Thank you.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,877

Re: No headphone output in stand-alone.

Save your normal state into one of the 6 Setups, then in stand-alone mode load that Setup. This will ensure TM FX and some more is configured correctly.

Regards
Matthias Carstens
RME

MC's Website