• Registered: 2015-01-15
  • Posts: 2

Topic: DIGI Check analyze the entire signal

Hi there!
I recently bought a sound card RME Fireface UC and after installing all the drivers updated, open DIGICheck in mode Totalyzer and TotalFX check the output channel AN 1/2 to "Loopback" for look the spectrum of what is played in MAin Output ...
Here the (stupid) question...the signal must be analyzed on the basis of how much gain is given by TotalMix or the volume knob on the sound card ... it would be possible to analyze the entire signal, without the need to turn up the volume to view it?

Thanks so much for your time
and sorry for the bad english

  • Registered: 2007-05-09
  • Posts: 646

Re: DIGI Check analyze the entire signal

You could use another submix to an unused hardware out and then use the loopback on this one.

  • Registered: 2015-01-15
  • Posts: 2

Re: DIGI Check analyze the entire signal

Can be a good idea...but i dont have any unused hardware sad