Hey Everyone,

I am brand new (4 hours ago) to RME and Totalmix FX as I just purchased a Babyface Pro for use in my studio. I have been going through the manual trying to figure out how to program a basic routing setup for my current project. Here is my scenario...

I am using Figure53 Qlab and need 4 separate outputs for a quad monitoring setup. How am I able to route QLab software outputs 1-4 to the Babyface outputs 1/2 and a headphone output. I have two monitors hooked up to AN 1/2 and the rear speakers plugged into the headphone output using a 1/4" TRS to dual 1/4".

For the life of me I can't seem to configure Totalmix FX properly so I can get my 4 software outputs to my 4 hardware outputs.

What am I missing?...

Any advice would be great!

Thanks