1 Topic by TVbene (edited by TVbene 2020-02-04 13:59:06)

  • Registered: 2020-02-04
  • Posts: 2

Topic: Clicking on individual output - cannot apply individual routing

Hello,
I'm trying to save different routings as snapshots, which I understand could be triggered via MIDI.
But changes in the routing seem to be applied to every output, does not matter which one is selected. Since all ouput channels look like they are highlighted, could I have selected all of them somehow or something like that?
Maybe someone knows this behaviour, it used to work before.

  • Registered: 2019-09-02
  • Posts: 24

Re: Clicking on individual output - cannot apply individual routing

Sounds like TotalMixFX routing mode is set to 'Free' mode and not 'Submix'. This can be changed via the blue panel in TotalmixFX window.

mark.cull's Website

  • Registered: 2020-02-04
  • Posts: 2

Re: Clicking on individual output - cannot apply individual routing

Thanks so much! It wasn't that but this way I found out that in the same window I had to deselect "trim" under SHOW.