• Registered: 2019-01-17
  • Posts: 2

Topic: Interfaces driver compatibility

Hi, and sorry if i posted this in the wrong section, i didn't know where to post this.

I bought a Babyface Pro FS a while ago (great interface by the way) and i was planing on expanding the I/Os with a MultifaceII via ADAT. Question is: Since both use different drivers, can i use the PCI card only to power the Multiface without messing anything up? Would i still need to install the driver for the Multiface?

Thanks.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,769

Re: Interfaces driver compatibility

Yes. The different drivers also don't allow to see them both in ASIO apps. And Multiface I and II do not include full stand-alone operation and loose their state on power-off.

Regards
Matthias Carstens
RME

MC's Website