• Registered: 2013-10-09
  • Posts: 10

Topic: Using Babyface Pro for as bass headphone amp?

I have both a Babyface and a Babyface Pro, and was hoping to use the latter in standalone mode as a headphone amp for practicing bass guitar. It's easy enough to get the instrument output in one side of the headphones, and it sounds good, but is it possible to monitor in mono or otherwise route one instrument input to both channels of the headphone output? Thanks!

2 Reply by ramses (edited by ramses 2021-02-13 08:06:56)

  • ramses
  • DAW Mastermind
  • Offline
  • From: UTC+1
  • Registered: 2012-10-14
  • Posts: 12,869

Re: Using Babyface Pro for as bass headphone amp?

Sorry, don't have the Babyface and currently no time to test, but from memory .. did you try already that:

In TM FX HW inputs (top row): is the channel AN1 a mono channel or do you use AN1/2 stereo ?
Press the "tool/wrench" icon and set it to mono if required.
AFAIR a Mono channel is routet to both channels if you have a stereo output.

Otherwise, already tried the mono button in the TM FX control room ?

BR Ramses - UFX III, 12Mic, XTC, ADI-2 Pro FS R BE, RayDAT, X10SRi-F, E5-1680v4, Win10Pro22H2, Cub13

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,438

Re: Using Babyface Pro for as bass headphone amp?

In stand-alone mode panning is not supported.

Regards
Matthias Carstens
RME

MC's Website