• Registered: 2017-05-18
  • Posts: 28

Topic: Adi-2 Pro ... Sorry ... I don't get it ...

I try to go from Menu "I/O - "Parametric EQ" to "Settings and all other submenus. No idea how to go one level higher I am stuck in the parametric EQ menu.
With encoder 2 I can step through all EQ bands the same does pushing encoder 1. If I turn encoder 1 I only switch between the I/O's ... but still in submenu "Parametric EQ" ...

2 Reply by KaiS (edited by KaiS 2023-02-12 00:11:05)

  • KaiS
  • DAW Mastermind
  • Offline
  • From: Germany
  • Registered: 2020-02-05
  • Posts: 3,525

Re: Adi-2 Pro ... Sorry ... I don't get it ...

Press Encoder1 until the circled (2) appears after “Parametric EQ”.
Turn Encoder2 to get to the other submenus “Settings”, Bass/Treble and Loudness.

Watch out for the circled (1) or (2) at the end of the menu entries, this is the Encoder number to turn.

Encoder1 turn always changes the top line menu.
Encoder2 turn always changes the selected menu entry’s value.
Encoder1/2 push moves the menu entry selection (“cursor”) up and down.

KaiS's Website

  • Registered: 2017-05-18
  • Posts: 28

Re: Adi-2 Pro ... Sorry ... I don't get it ...

KaiS wrote:

Press Encoder1 until the circled (2) appears after “Parametric EQ”.
Turn Encoder2 to get to the other submenus “Settings”, Bass/Treble and Loudness.

Watch out for the circled (1) or (2) at the end of the menu entries, this is the Encoder number to turn.

Encoder1 turn always changes the top line menu.
Encoder2 turn always changes the selected menu entry’s value.
Encoder1/2 push moves the menu entry selection (“cursor”) up and down.

Thank you so much. I simply did not figure out to step up from single settings further with encoder 1 until a circled 2 shows the option to get to other submenus.