• Registered: 2023-05-03
  • Posts: 8

Topic: Babyface Input/Output not showing up on logic pro x

Mac Ventura 13.3.1

Downloaded driver_usb_mac_331

fut_usb_mac (2)

Not showing up on Logic pro still.

Every time I click on RME USB Series Flash Tool it closes. (Have granted permission on security and rebooted)

Is there something I'm missing?

Thank you

2 Reply by waedi (edited by waedi 2024-03-20 02:41:30)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,560

Re: Babyface Input/Output not showing up on logic pro x

Is it connected to the mac directly without any hub ? It should.
Is it showing up in the system report under USB ?
Is it showing up in the Audio-MIDI-Setup ?

Can Fireface Settings Dialog open ?
Can Totalmix FX open ?

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,600

Re: Babyface Input/Output not showing up on logic pro x

> Have granted permission on security and rebooted

Unclear. Did you lower Security Settings in Recovery mode? If so, did you allow the driver during installation in Privacy & Security?

Regards
Matthias Carstens
RME

MC's Website