• Registered: 2020-04-13
  • Posts: 6

Topic: Power-on Clock 768kHz -> 192kHz ?

I am an RME ADI-2 Pro FS R Be user.

When powered on, the internal clock is 768 kHz. Can I change the settings and make it 192 kHz? My digital speaker only supports up to 192 kHz, so it doesn't sound at 768 kHz.

I wish I could change the settings. I've read the manual many times and I don't think there's such a setting. If there's a way, I'd appreciate it if you could let me know.

Thank you.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,582

Re: Power-on Clock 768kHz -> 192kHz ?

The unit remembers the last used setting. For Preamp mode you can change it and it will remember. If you connect it by USB the operating system of the connected computer or tablet sets the sample rate. This can be changed in the used apps or the OS.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2020-04-13
  • Posts: 6

Re: Power-on Clock 768kHz -> 192kHz ?

MC wrote:

The unit remembers the last used setting. For Preamp mode you can change it and it will remember. If you connect it by USB the operating system of the connected computer or tablet sets the sample rate. This can be changed in the used apps or the OS.

I checked again. It wasn't an ADI-2 problem, it was a source device(Eversolo A6) problem.
I noticed that the source device sets it to 768 kHz when it boots.

Thank you for your reply.