1 Topic by switch6343 (edited by switch6343 2024-09-17 20:00:41)

  • From: Central Switzerland
  • Registered: 2022-02-23
  • Posts: 29

Topic: AutoDark Mode (Display Mode) - increase default value of 3 seconds

I enabled AutoDark Mode. However, a key press and turning an encoder will temporarily activate LEDs and display for only 3 seconds, which I consider as very very short.

Is there a way to increase the 3 seconds to e.g. 1 minute or even better to allow to select different time values e.g. 3 seconds, 60 seconds, 120 seconds etc. or e.g. increments of 60 seconds to a max of e.g. 300 second (5 minutes)?

  • Registered: 2021-12-24
  • Posts: 47

Re: AutoDark Mode (Display Mode) - increase default value of 3 seconds

I second this!
3 seconds is too short!!

3 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,586

Re: AutoDark Mode (Display Mode) - increase default value of 3 seconds

AutoDark has a direct button on the remote. If you need it that long it's a one time press to deactivate, and another to activate it again...

Regards
Matthias Carstens
RME

MC's Website

  • From: Central Switzerland
  • Registered: 2022-02-23
  • Posts: 29

Re: AutoDark Mode (Display Mode) - increase default value of 3 seconds

Matthias, thanks, that does the trick.

  • Registered: 2024-10-07
  • Posts: 1

Re: AutoDark Mode (Display Mode) - increase default value of 3 seconds

Allow me to propose an implementation in the firmware of the Adi-2 FS model.

It would be useful to be able to set a time for the activation of the autodark function, for example 30 seconds / 1 minute etc...

I think it would also be excellent if the red stand by LED deactivated automatically after a pre-established time (e.g. 20 minutes). Thank you for the excellent work you do and possibly for considering the suggestions.