1 Topic by oliver77 (edited by oliver77 2024-11-25 20:36:47)

  • Registered: 2024-11-25
  • Posts: 2

Topic: Totalmix didn't recognize UFX iii

Hi, I previously ran a Firewire 800 on my Mac. Today the new UFX 3 connected and driver installed.

In the Fierface USB Settings the UFX is visible and when I turn on ADAT channels this is also visible.

But in Totalmix I can not open a window and it also shows no device to choose from. On the UFX it displays host. Stanalone/CC should be off.

Uff, anyone have an idea? Please help..

2 Reply by waedi (edited by waedi 2024-11-26 01:41:41)

  • waedi
  • DAW Mastermind
  • Offline
  • From: Swiss Zürich
  • Registered: 2020-12-08
  • Posts: 4,836

Re: Totalmix didn't recognize UFX iii

oliver77 wrote:

Hi, I previously ran a Firewire 800 on my Mac. Today the new UFX 3 connected and driver installed.

In the Fierface USB Settings the UFX is visible and when I turn on ADAT channels this is also visible.

Not clear what that means. Where do you turn on Adat ? You mean switch ADAT into SPDIF in the Settings ?
And where do you see it is visible ?

Also check this : https://forum.rme-audio.de/viewtopic.ph … 77#p228077

oliver77 wrote:

But in Totalmix I can not open a window and it also shows no device to choose from. On the UFX it displays host. Stanalone/CC should be off.

Uff, anyone have an idea? Please help..

M1-Sequoia, Madiface Pro, Digiface USB, Babyface silver and blue
  • Registered: 2024-11-25
  • Posts: 2

Re: Totalmix didn't recognize UFX iii

Thank you for response. I ment with ADAT that i connected a Behringer Ultragain.
But i solved the problem. Like always i should read exactly :-)

So i had to install the kernel driver for Intel Chips and here i go.
Solved!

Thanks!