• Registered: 2010-10-09
  • Posts: 19

Topic: Sync issue with RME ADI8 DS and HDSP 9652

I have the HDSP 9652 running adat out into the ADI8 DS adat in main.  Occasionally I will lose sync on the D/A, and of course the audio.  ADI8 settings are AD clock internal (clock at 48) DA clock is input.  I am only using the D/A side.  RME card setting are autosync (it is synced to a lucid 88192 adat 1)

The D/A input sync light blinks, and I pull the ADAT cable in and out, and it seems to catch.  After a couple of times it seems to stay.  This problem starts upon boot of my system.

Any advice?

thanks

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,779

Re: Sync issue with RME ADI8 DS and HDSP 9652

Set AD clocking to the same value (here ADAT Input). If that doesn't help then I would guess that the unit needs repair somehow.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2010-10-09
  • Posts: 19

Re: Sync issue with RME ADI8 DS and HDSP 9652

I tried setting the AD to adat input, and still the same problem.  It seems to work after it warms up for about 15 minutes.  Sync stays put.

Is there a repair facility in San Francisco, CA?  thanks