• Registered: 2014-12-05
  • Posts: 2

Topic: Fireface 802 & Totalmix - controlling output levels

I recently bought my first Fireface 802 and installed Totalmix on my MacBook Pro. I'm using the Fireface for multiple outputs in a small theatre show - four analogue outputs in total. My problem is that the speakers don't seem to be outputting the same levels as one another. Also I somehow managed to end up with output 3 driving speakers 1 and 3 (even though output 1 works okay when used on its own). My DAW is QLab if that makes a difference.
Any suggestions would be much appreciated. I tried resetting Totalmix but for some reason the main outputs (1 & 2) don't output the same level as 3 & 4 ...

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,877

Re: Fireface 802 & Totalmix - controlling output levels

Open the settings panel of the outputs and check the level reference.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2014-12-05
  • Posts: 2

Re: Fireface 802 & Totalmix - controlling output levels

Thanks Matthias. I think my problem was in the matrix window which I had to reset one to one. I didn't find it particularly intuitive though, compared to other mix controllers. There doesn't seem to be an option to do this with one click.