Hi,

I updated the driver today to 4.06.0.  I also the flash update tool to give 154 on the card.

I switched off and rebooted the PC.

I can get basic stereo sound through the card, but when I go to the Windows Sound in control panel.  I look at the properties for the device and I see that the only Sample Rate listed is whatever is set in the Hammerfall DSP setting.  If I change it in Hammerfall it changes in the windows window.  Previoulsy however the windows sound window listed all available sample rates.

Also if I try to test the supported formats (such as Dolby Digital) I get the error message "Windows was unable to play the test tone.  Support for this format will be disabled."

Can anyone point me at some settings to restore the ability to play encoded formats ?

Thanks
Paul