You are not logged in. Please login or register.
RME User Forum → HDSP(e) series → ADI-8 DS question
Hi All.
Is it possible to set the ADI-8 DS so that an input to channels 1&2 analogue in are mirrored to the analogue outputs 1&2?
It seems that it should be but the manual is not clear on this & I am reluctant to fiddle with a working setup in ignorance.
(Currently, I seem to need to bounce the signal through the DAW)
If it is connected to a hdsp card or ufx etc (or any other brand too probably) you can use the mixer app for that instead of your daw. I use it for complex setups with life mics and effects from 3 adat sources and destinations on my HDSP9652.
I have the ADI8AE which I think is identical to the DS and there is no way to do this internally. Except with an adat loopback, but that is not very useful!
Damn.
An ADAT loopback is not possible - both ports are used for 96kHz operation.
I am amazed this is not possible to do really. It would seem to be such a basic thing yet no go it appears.
The Combine function does it for digital - so why no analogue switch?
FWIW, I cannot find any way to do this in Totalmix either - nothing seemed to work when I tried this yesterday.
Maybe it is time to get new converters
This functionality has been added in the ADI-8 DS MK III, but only for all 8 channels at the same time.
But I don't see where the problem is doing this with TotalMix. Send ADAT input signal to the correct ADAT output...
Yes I do this all the time, so keep trying! It is as easy as sending you daws output to any analogue output and same principle! And it is much more flexible then a switch on the converter!
RME User Forum → HDSP(e) series → ADI-8 DS question
Powered by PunBB, supported by Informer Technologies, Inc.