RoomEQ now available for Fireface 802 FS and HDSPe MADI FX!

mr. anxiety · 2015-05-26 01:00:55

I have (2) HDSP 9652 e cards installed in my PC, W7, Cubase 7.5.3

RME driver 4.04

I clock from a Big Ben.

I have WC BNC cables in to Card 1 from Big Ben, cable out from WC Card 1to WC in Card 2.

The jumper on daughter card of Card 1 is not set to terminate.
The jumper on daughter card of Card 2 is set to terminate.

I have green light status on both cards.

I have WC selected for both cards in the DSP app and a WC lock in SyncCheck.

I do not have a green LED Lit for WC termination on the Big Ben. On my 5 other slave PCs with RME cards, I have a green light

Thoughts?

Nuendo 3 Dual Xenon 2.66 w/ HDSP 9652 2.94 + (2) Uad-1 Cards ver 4.9.0

MC · 2015-05-26 03:52:31

> The jumper on daughter card of Card 1 is not set to terminate.

The input is not terminated. WC out is a newly generated word clock signal, so termination at card 2 does not influence input card 1 at all.

Regards
Matthias Carstens
RME

mr. anxiety · 2015-05-26 06:50:09

Thanks for your reply.

Is it possible for you to give me the correct way to have this set-up so I can have a successful termination back to my Big Ben?

I appreciate your help in this matter.

Thanks,

Mr. A

Nuendo 3 Dual Xenon 2.66 w/ HDSP 9652 2.94 + (2) Uad-1 Cards ver 4.9.0

MC · 2015-05-26 12:08:18

Simply push the switch for termination on input 1 - that's it. The rest stays as it is.

Regards
Matthias Carstens
RME

(2) Hdsp 9652e Cards in PC - Word Clock Termination issue