1 Topic by Animus (edited by Animus 2015-06-02 13:57:11)

  • Registered: 2007-09-18
  • Posts: 17

Topic: ADI-8 DD problem?

hey all, I having issues with my ADI-8 DD.  It had been functioning perfectly for years.  Earlier today I had turned it off and then back on again and it normally would start flashing with green lights as it would seek lock.  This time all I get is faint red solid lights on all the input and output state channels, the SRC and AES state leds.  No buttons are responsive.  Any ideas?  power supply maybe?

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,675

Re: ADI-8 DD problem?

Most probably.

Regards
Matthias Carstens
RME

MC's Website

  • Registered: 2007-09-18
  • Posts: 17

Re: ADI-8 DD problem?

thanks Matthias. I checked the pins on the molex going to CON1 on the main board and it's reading only 2.6 or so volts. What should that be? 5 volts?

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,675

Re: ADI-8 DD problem?

Yes.

Regards
Matthias Carstens
RME

MC's Website

5 Reply by Animus (edited by Animus 2015-06-06 01:15:53)

  • Registered: 2007-09-18
  • Posts: 17

Re: ADI-8 DD problem?

Cool thanks!  I had talked to Jeff Peterson from Synthax US earlier today and have a new power supply already on the way!  Great service all around.