• Reteb
  • ADAT user
  • Offline
  • Registered: 2007-12-31
  • Posts: 15

Topic: cannot see separate adat outputs in Nuendo4

In the past, in my previous computer system, while playing back, I could see all active audio tracks in Nuendo4 as active separate ADAT output channels in Totalmix.

Now, in my new system, Nuendo4 and HDSP work OK but any more than 2 active audio tracks in Nuendo 4 mix down to 2 ADAT outputs instead of showing the separate ADAT output channels.

What do I oversee ?

Thanks for help.

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,433

Re: cannot see separate adat outputs in Nuendo4

Nuendo 4 device configuration - Reset I/Os, then check the VST connections.

Regards
Matthias Carstens
RME

MC's Website

  • Reteb
  • ADAT user
  • Offline
  • Registered: 2007-12-31
  • Posts: 15

Re: cannot see separate adat outputs in Nuendo4

Thanks !
It works properly now again just as in the past.
Obviously too many  years ago I used my HDSP9652 :-)

One thing : whatever I try in outputting  ADAT mono channels ( which in itself works OK ) in TotalMix I always see unsolicitedly  two channels linked.
Is this an ( automatic ) TotalMix prerequisite  which cannot be passed by ?

Thanks again.

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,433

Re: cannot see separate adat outputs in Nuendo4

A screenshot might be helpful...

Regards
Matthias Carstens
RME

MC's Website

  • Reteb
  • ADAT user
  • Offline
  • Registered: 2007-12-31
  • Posts: 15

Re: cannot see separate adat outputs in Nuendo4

I guess, but not sure,  I resolved my issue.
If not I'll post prscr's of the relevant Nuendo 4Workspace, N4 Mixer and Totalmix 2functions.

Thanks again, good help !

Peter.