• Registered: 2011-10-15
  • Posts: 3

Topic: help needed getting rme adat into Logic Pro X

Hi

I have a focusrite octopre connected via ADAT to my RME Babyface.

In totalmix, I can see a signal appearing in AS 1/2 just one channel.  If I switch microphone to another octopre channel (there are 8) then the same totamix channel responds.

I cannot get anything from the Babyface via totalmix to show up in Logic Pro X.

Can someone explain the best way to get this Focusrite 8 channel to connect via RME Babyface ADAT to Logic Pro X so I can use all 8 channels.

Barry

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,849

Re: help needed getting rme adat into Logic Pro X

Set everything to 44.1 or 48 kHz sample rate.

Regards
Matthias Carstens
RME

MC's Website