• 2RME
  • ADAT user
  • Offline
  • Registered: 2016-10-02
  • Posts: 8

Topic: RME 9652 termination: is this the right setting?

Hey guys quick question, I just want to make sure,
I have to set my second RME 9652 as "terminated" as is going to be the last in the chain, there's a jumper on the expansion board to do that but I'm not sure
in which position I have to put it on for it to be terminated.

The manual says when shipped from the factory the BNC input is NOT terminated, and yet as you can see in the picture the jumper x105 appears
to be in the 75ohm position (according to diagram at the bottom) which should
mean IS in the terminated position, am I interpreting this wrong?
http://i66.tinypic.com/20j3f9j.jpg

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,683

Re: RME 9652 termination: is this the right setting?

This is unterminated. You need to connect the pin by the notch in the silkscreen as shown in the diagram (rotate the image 180 degrees).

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • 2RME
  • ADAT user
  • Offline
  • Registered: 2016-10-02
  • Posts: 8

Re: RME 9652 termination: is this the right setting?

Jeff wrote:

This is unterminated. You need to connect the pin by the notch in the silkscreen as shown in the diagram (rotate the image 180 degrees).

Thank you Jeff, kind of counter-intuitive but that's what I was thinking as well,
so to terminate it I'll put the jumper all the way to the right (looking at the picture) in the other position