Assistance required to connect the following interfaces via madi.

RME ADI8-QS, FERROFISH A16 MK II, RME OCTAMIC XTC.

I need some information on the correct connection procedure if possible.

My setup is 32 channel 96k 24 bit via RME MADI HDSPE PCI Express Card.

I would like the analog inputs/outputs to appear in the following order, through my sequencer/recording software……..

RME ADI8-QS                    ANALOG I/O 01-08
FERROFISH A16 MK II                ANALOG I/O 09-24
RME OCTAMIC XTC                ANALOG I/O 25-32

Is there a set procedure/order to connect the madi i/o cable in order to use all three units ?
I can set the “Device ID” for the RME hardware, but I cannot get A16 MK II device ID information.