• Liggy
  • ADAT user
  • Offline
  • Registered: 2016-03-15
  • Posts: 17

Topic: Vector does not show stereo

When i put Totalyser on master, the stereo image is always shown mono even it is stereo signal.

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,664

Re: Vector does not show stereo

Check your input configuration in Digicheck, sounds like you have the same channel selected for L & R.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • Liggy
  • ADAT user
  • Offline
  • Registered: 2016-03-15
  • Posts: 17

Re: Vector does not show stereo

Jeff wrote:

Check your input configuration in Digicheck, sounds like you have the same channel selected for L & R.

Fixed smile I just checked something in settings (input device settings if i remember) and both channels were set to analog 1. But it strange it is set up like that by default.

Besides, i checked if it was problem in Total Mix and somehow both analog 1,2 were playing mono center (dumb me for not noticing because speakers were acting weird in last 2 days xD ) But that was not the problem because i changed software playback 1 & 2 to stereo.

Anyway thanks bro wink