1 Topic by itsrich (edited by itsrich 2018-10-28 05:18:29)

  • From: Fort Worth, TX
  • Registered: 2018-10-06
  • Posts: 15

Topic: UFX+ ADAT clocking to OctaMic II & Audient ASP800?

Getting started with the UFX+

Would like to connect an OctaMicII & Audient ASP800 via ADAT.

Can I do this with ADAT LightPipe cables only or do I need a word clocking cable/connection?

I have the RME CLOCK SOURCE settings to 'Internal'

Also - would this be easier/more stable if I were using 2 OctaMicII's via ADAT? 

thanks for any advice.

itsrich's Website

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 25,443

Re: UFX+ ADAT clocking to OctaMic II & Audient ASP800?

1. Of course. No word needed.

2. Correct.

3. Can't comment on the Audient, sorry..

Regards
Matthias Carstens
RME

MC's Website

3 Reply by itsrich (edited by itsrich 2018-10-28 07:08:35)

  • From: Fort Worth, TX
  • Registered: 2018-10-06
  • Posts: 15

Re: UFX+ ADAT clocking to OctaMic II & Audient ASP800?

Thank you MC. 

Can you list the settings for 2 OctaMicII’s to lock via light pipe to a UFX+ or point me to where this might be documented ?

Many thanks,
Rich

itsrich's Website