• Registered: 2019-08-27
  • Posts: 2

Topic: accessing even numbered line outputs while in Channel mode

Hello everyone,

First time poster here! I just purchased a Fireface UCX and have been going through the manual to gain an idea of how to use the interface. One thing that isn't clear to me yet is when in Channel mode I only see in the display 'L1, L3, L5' for line outputs. I do not see any of the even numbered outputs. The same for the ADAT outputs. How do I access 'L2, L4, L6' if I need to adjust levels for these channels?

Hopefully this is an easy one. I did search the faq, forum as well as the web but couldn't find anything. My apologies if this has been covered before.

Thanks in advance!
jpm

  • Jeff
  • Jeff
  • Moderator
  • Offline
  • From: USA
  • Registered: 2007-05-21
  • Posts: 4,650

Re: accessing even numbered line outputs while in Channel mode

They are pairs in stereo mode. To change to Mono mode, hold the knob button down for a few seconds, OF(f) will flash on the screen. Do it again and it says ON for stereo mode again.

Regards,
Jeff Petersen
Synthax Inc.

Jeff's Website

  • Registered: 2019-08-27
  • Posts: 2

Re: accessing even numbered line outputs while in Channel mode

Thank you Jeff. The described behavior did not happen when I held the rotary knob down but I did solve the issue by enabling 'Set all channels to mono' under Options > Reset Mix. All is well, thanks again!